Pfannenberg DTS-Serie Betriebsanleitung Seite 123
Anbau- und einbau-kühlgeräte/standard-controller (sc) – 400 / 460 v, 3
Vorschau ausblenden
Andere Handbücher für DTS-Serie:
- Betriebsanleitung (396 Seiten) ,
- Betriebs- und montageanleitung (24 Seiten) ,
- Betriebs- und montageanleitung (24 Seiten)
Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENG
Assembling the unit cover
Fig. 25: Assembling the unit cover
Operating Manual | Attachment and Installation Cooling Units | Standard Controller (SC) – 400 / 460 V, 3~ | 086100123
Prerequisite
DANGER – Danger to life due to electric shock. Make sure that the
unit is voltage-free.
Wait for a discharge phase of 10 minutes for the electrical components.
The unit should only be opened afterwards.
Procedure
1.
Plug the earthing cable (3) into the inside of the unit cover (2).
2.
Push the lugs (4) of the unit cover into the slits (5) in the floor plate.
3.
Plug the earthing cable (3) into the inside of the unit cover.
4.
Close the unit cover again.
ATTENTION – Damage to the unit.
When closing the unit cover, make sure that the earthing cable (3) is
not trapped.
5.
Fasten the unit cover with the four screws (1).
The unit cover is assembled.
G00072
55/68
Werbung
Inhaltsverzeichnis
