Service Interface - Pfannenberg DTS-Serie Betriebsanleitung
Anbau- und einbau-kühlgeräte/standard-controller (sc) – 400 / 460 v, 3
Vorschau ausblenden
Andere Handbücher für DTS-Serie:
- Betriebsanleitung (396 Seiten) ,
- Betriebs- und montageanleitung (24 Seiten) ,
- Betriebsanleitung (267 Seiten)
Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENG
5.3
Service interface
Fig. 23: Service interface
1
Service interface on the controller
The service interface enables operating parameters to be changed.
•
A USB adapter and the configuration software ECoolPLANT 2.X, including the USB driver software are required for this.
•
The connection for the USB adapter is marked on the circuit diagram with the device tag X28.
•
The USB adapter enables connection to a computer that operates with the configuration software ECoolPLANT 2.X.
–
The USB adapter is available as an accessory, see chapter "Spare parts and accessories", Page 65.
–
Remove the USB adapter from the unit after use. The service interface is only intended for temporary data
exchange, e.g. to read out system messages. Continuous operation is forbidden.
NOTE
•
•
NOTE
For a detailed description of the error messages and troubleshooting notes, see section "Error messages", Page 59.
Operating Manual | Attachment and Installation Cooling Units | Standard Controller (SC) – 400 / 460 V, 3~ | 086100123
The ECoolPLANT software is available as a free download on the website Fehler! Linkreferenz
ungültig.. Alternatively, simply scan the QR code opposite.
The appropriate operating manual for the ECoolPLANT software is available for downloading under
Fehler! Linkreferenz ungültig.
2
USB adapter
G00078
49/68
Werbung
Inhaltsverzeichnis
