Printing; Ac40 Stand Alone Unit, Print Logo Update - Interacoustics AC40 Gebrauchsanweisung

AC40 Instructions for Use - US

3.7 Printing

The data from the AC40 can be printed in 2 ways:
•
Direct printout: Allows results to be printed directly after testing (via a supported USB printer –
please contact Interacoustics customer service for a list of supported PC printers if in doubt). The
printout logo can be configured via the audiometer itself (see below) or via the Diagnostic Suite
(in the General Setup a logo impage can be downloaded to the instrument from the PC).
•
PC: Measurements can be transferred to the Diagnostic Suite PC program (see separate
operational manual) and printed via this. This allows printouts to be fully customized via the Print
Wizard. It also allows for combined printouts – e.g. together with the AT235 or Titan Middle Ear
Anlyzers.

3.8 AC40 Stand Alone Unit, Print Logo Update

1. Open up the "Paint" program
2. Open up "Image Properties", by pushing the Ctrl + E keys
3. Set the "Width" to 945 and the "Height" to 190 as shown. Click on "OK"
4. Edit the Image and the Company data to fit inside the set area
5. Save the created file as "PrintLogo.bmp"
6. Zip the "PrintLogo.bmp" file to the following name "update_user.logo.bin"
The "update_user.logo.bin" file is now ready to be used
7. Find a USB thumb drive with at least 32MB in total size and insert it into your PC
8. Go to My Computer and right click on the USB thumb drive and select 'Format' **Note-this
will erase everything on your USB thumb drive*
9. Ensure that 'FAT32 is selected as your File System- Leave other settings as listed
10. Click Start-depending on the size of your thumb drive these may take a while. When the
format is complete you will receive a pop-up indicating it has formatted successfully
11. Copy "update_user.logo.bin" file onto the formatted thumbdrive
12. It is very important that this file and only this file is present on the USB thumb drive
Page 41