Installation - Mettler Toledo IND570 Installationsanleitung

2.

Installation

IF YOU WISH TO INSTALL THE IND570xx VERSION TERMINAL IN A DIVISION 2 OR ZONE 2/22 AREA, REFER TO THE
ADDITIONAL DIVISION 2 AND ZONE 2/22 INSTALLATION INSTRUCTIONS 30205321 INCLUDED ON THE RESOURCE
CD PROVIDED WITH THE TERMINAL. FAILURE TO COMPLY WITH THE INSTRUCTIONS PROVIDED THERE COULD
RESULT IN BODILY HARM AND/OR PROPERTY DAMAGE.
This chapter covers
•
Opening and Closing Enclosures
•
Environmental Protection
•
Mounting the Terminal
•
Installing Cables and Connectors
•
PCB Switch Settings
•
PCB Jumper Positions
•
Capacity and Increment Label Instructions
•
Sealing the Enclosure
30205319 | 04 | 08/2016
DIV 2 AND ZONE 2/22 INSTALLATION
This chapter provides installation instructions for the IND570 terminal
panel-mount and harsh enclosures. Please read this appendix thoroughly
before beginning installation.
NOT ALL VERSIONS OF THE IND570 ARE DESIGNED FOR USE IN HAZARDOUS (EXPLOSIVE)
AREAS. REFER TO THE DATA PLATE OF THE IND570 TO DETERMINE IF A SPECIFIC TERMINAL IS
APPROVED FOR USE IN AN AREA CLASSIFIED AS HAZARDOUS BECAUSE OF COMBUSTIBLE OR
EXPLOSIVE ATMOSPHERES.
DIV 2 AND ZONE 2/22 INSTALLATION
VERSIONS OF THE IND570 TERMINAL THAT ARE NOT FACTORY LABELED AS DIVISION 2 OR ZONE
2/22 APPROVED MUST NOT BE INSTALLED IN A DIVISION 2 OR ZONE 2/22 ENVIRONMENT.
DO NOT INSTALL, DISCONNECT OR PERFORM ANY SERVICE ON THIS EQUIPMENT BEFORE
POWER HAS BEEN SWITCHED OFF OR THE AREA HAS BEEN SECURED AS NON-HAZARDOUS BY
PERSONNEL AUTHORIZED TO DO SO BY THE RESPONSIBLE PERSON ON-SITE.
ONLY THE COMPONENTS SPECIFIED IN THE IND570 DOCUMENTATION CAN BE USED IN THIS
TERMINAL. ALL EQUIPMENT MUST BE INSTALLED IN ACCORDANCE WITH THE INSTALLATION
INSTRUCTIONS DETAILED IN THE INSTALLATION MANUAL. INCORRECT OR SUBSTITUTE
COMPONENTS AND/OR DEVIATION FROM THESE INSTRUCTIONS CAN IMPAIR THE SAFETY OF
THE TERMINAL AND COULD RESULT IN BODILY INJURY AND/OR PROPERTY DAMAGE.
METTLER TOLEDO IND570 Weighing Terminal Installation Manual
WARNING!
WARNING
WARNING
2-1