Installation - Mettler Toledo IND570 Installationshandbuch

2

Installation

This chapter covers
·
Opening and Closing Enclosures
·
Environmental Protection
·
Mounting the Terminal
·
Installing Cables and Connectors
·
PCB Switch Settings
·
PCB Jumper Positions
·
Capacity and Increment Label Instructions
·
Sealing the Enclosure
30205319 | 02 | 04/2015
This chapter provides installation instructions for the IND570 terminal
panel-mount and harsh enclosures. Please read this chapter thoroughly
before beginning installation.
NOT ALL VERSIONS OF THE IND570 ARE DESIGNED FOR USE IN HAZARDOUS (EXPLOSIVE)
AREAS. REFER TO THE DATA PLATE OF THE IND570 TO DETERMINE IF A SPECIFIC TERMINAL IS
APPROVED FOR USE IN AN AREA CLASSIFIED AS HAZARDOUS BECAUSE OF COMBUSTIBLE OR
EXPLOSIVE ATMOSPHERES.
DIV 2 AND ZONE 2/22 INSTALLATION
TERMINALS THAT ARE NOT FACORY LABELED AS DIVISION 2 OR EUROPEAN CATEGORY 3
APPROVED MUST NOT BE INSTALLED IN A DIVISION 2 OR ZONE 2/22 ENVIRONMENT.
DO NOT INSTALL, DISCONNECT OR PERFORM ANY SERVICE ON THIS EQUIPMENT BEFORE
POWER HAS BEEN SWITCHED OFF OR THE AREA HAS BEEN SECURED AS NON-HAZARDOUS BY
PERSONNEL AUTHORIZED TO DO SO BY THE RESPONSIBLE PERSON ON-SITE.
ONLY THE COMPONENTS SPECIFIED IN THIS MANUAL CAN BE USED IN THIS TERMINAL. ALL
EQUIPMENT MUST BE INSTALLED IN ACCORDANCE WITH THE INSTALLATION INSTRUCTIONS
DETAILED IN THIS MANUAL. INCORRECT OR SUBSTITUTE COMPONENTS AND/OR DEVIATION
FROM THESE INSTRUCTIONS CAN IMPAIR THE SAFETY OF THE TERMINAL AND COULD RESULT
IN BODILY INJURY AND/OR PROPERTY DAMAGE.
METTLER TOLEDO IND570 Weighing Terminal Installation Manual
WARNING!
WARNING
WARNING
2-1