Adjustment Of The Motion Detector; Changing The Bulb - LIVARNO LUX LSHB 150 A1 Bedienungsanleitung

Adjustment of the motion detector

Changing the bulb

LSHB 150 A1
Downloaded from www.Manualslib.com
The adjustment of the range, the twilight level, and the illumination time is made
with the rotary switches on the motion detector
Twilight level (LUX
Adjustment of the brightness level below which the motion detector
The brightness sensor is adjustable from 5 Lux
Illumination time (TIME
Adjustment of the illumination time from 7 seconds to 12 minutes. If the appliance
is switched on and it registers a new movement, the illumination time is extended
by the set value.
NOTICE
► We recommend setting the illumination time to the maximum, so as to
achieve the longest service life for the bulb
3
Range (SENS )
Setting the range of motion detector
♦ Finally, set the motion detector
♦ Fix the position of the motion detector
The supplied bulb is excluded from the warranty. Please use only bulbs
8
as specifi ed in the Technical Data.
♦ Switch the electrical circuit off and secure it against being inadvertently
switched back on.
♦ Loosen the screw
7
♦ Fold the front panel with the protective screen
♦ Change the bulb
8
dust-free soft cloth.
♦ Close the front panel, ensuring that the sealing gasket is properly seated
and clean.
♦ Firmly screw the front panel back down.
♦ Switch the electrical circuit back on and check the functioning.
manuals search engine
4
)
to 2000 Lux
2 )
8
to between 5 - 12 m.
4
according to your requirement.
4
with the locking screw
4
on the front panel.
. Do not touch the bulb with your bare hands, use a
.
will activate.
4
.
.
.
10
to the front.
6
GB
8
9