Vermeiren Inovys II Gebrauchsanweisung Seite 21

3.4.3 Push handles / push bar height
CAUTION
Always use the available adjustment holes on the push handle. Never exceed the maximum
height adjustment.
The push handles (16) and push bar (23) are connected and can
be adjusted in 7 different height positions:
1. Loosen both star knobs (31) on the handle supports and
remove them.
2. Adjust the height of both push handles simultaneously by
sliding them up/down in the supports. Make sure that the
holes on the inner/outer tube align.
3. Insert the two star knobs (31) in the supports and the
adjustment holes.
4. Turn the star knobs clockwise until they are finger-tight.
5. Make sure that the push handles are firmly secured.
3.4.4 Leg rest angle (BZ7-BZ8)
1. Loosen the lever (62) at the rotation point.
2. Adjust the angle of the leg rest by lifting/lowering the
footplates (between 100° - 190°).
3. Retighten the lever (62) firmly by hand.
4. Repeat this for the second leg rest. Make sure that
both leg rests are firmly secured.
3.4.5 Tip cap height
1. Press and hold the spring button (63).
2. Slide the tip cap tube (64) in/out of the frame tube.
3. Release the spring button.
4. Repeat this for the second tip cap. Make sure that both tip
caps are firmly secured.
Risk of injuries
Figure 9 Adjusting push-handle height
Figure 10 Adjusting footrest angle
Figure 11
Adjusting tip cap height
62
63
64
17
Inovys II, Inovys II kids
2021-11
Content
16
23
31
EN
NL