Auto Mode - VOLTCRAFT IR-1600 CAM Bedienungsanleitung

To get to the setting menu, push the button "Enter" in a measuring function. The menu "MEASURE SET" is opened.
Select by pushing the button "Enter" again. You can use the arrows to change the function/set value. To terminate,
push the button "ESC".
The following functions can be selected and set:
1
Emission
2
The emission degree can be set individually in this menu from 0.10 to 1.00 or selected with pre-set material values.
Possible set values are:
ε = x.xx set value 0.10 - 1.00
Cement (0.94)
Glass (0.92)
Human Skin (0.98)
Alarm High
3
Here, the upper alarm level (High) of the temperature can be set. You can enable or disable the function via the
selection field.
Possible set values are:
Time value = xx.x set value -50 to +1650 °C
Disable = Function is disabled
Alarm Low
4
Here, the lower alarm level (Low) of the temperature can be set. You can enable or disable the function via the selec-
tion field.
Possible set values are:
Time value = xx.x set value -50 to +1650 °C
Disable = Function is disabled
Laser
5
Here, the target laser during IR measuring can be switched on or off. Pushing the button "Enter" actuates the slider
in the display.
I = enabled, o = disabled

Auto Mode

6
Here, permanent measuring can be switched on or off. Pushing the button "Enter" actuates the slider in the display.
I = enabled, o = disabled
The automatic deactivation functions are disabled in permanent measuring mode. Ensure that you switch
off the meter after the measurement is completed.
Ice/Water (0.96)
Plastic (0.90)
Wood (0.87)
Enable = Function is enabled
Enable = Function is enabled
41