Auto Trigger - VOLTCRAFT IR1000-50CAM Bedienungsanleitung

Noted that the setting of the "IR CAM" mode is shared with the "IR MEASURE" mode,
the "DEWPOINT" mode and the "DATALOG" mode.
For optimal response time (150 ms), use the "IR MEASURE" mode.
set the emissivity of the target object
"EMISSIVITY"
•
•
set the alarm triggering temperature
"ALARM HIGH"
Alarm will be triggered when the temperature exceed the range.
•
"ALARM LOW"
•
•
laser
"LASER"
•
•

Auto trigger

"AUTO MODE"
When the auto mode is enabled, the IR measuring beam is triggered
continuously. The function will be disabled when you leave the IR
MEASURE mode Therefore, you need to enable it again if you re-enter the
IR MEASURE mode.
•
•
Select your desired preset material type:
- "CONCRETE"
- "GLASS"
- "HUMAN SKIN"
- "ICE / WATER"
- "PLASTIC"
- "WOOD"
or enter your customized ɛ. Select ɛ and press the button "ENTER" (6),
then use the button photo / up arrow (5) and the button video / down
arrow (3) to adjust the value.
Press the button ESC / power (4) to save and go back to the previous menu.
Select ENABLE to enable the function, then press the button "ENTER"
(6) and adjust the value by using the button photo / up arrow (5) and the
button video / down arrow (3).
Or select DISABLE to disable the function.
Press the button ESC / power (4) to save and go back to the previous menu.
Select ENABLE to enable the function or DISABLE to disable the
function.
Press the button ESC / power (4) to save and go back to the previous
menu.
Select ENABLE to enable the function or DISABLE to disable the
function.
Press the button ESC / power (4) to save and go back to the previous
menu.
33