Cleaning The Appliance - Gastroback Design Fleischwolf Plus Bedienungsanleitung

3. Grasp the cutter housing with one hand, then press the release button near the
gear hole in the front plate of the appliance. (See: ›Knowing Your Design Mincer
Plus‹)
4. With the release button pressed, unlock the cutter housing by turning it clockwise.
Then pull the cutter housing out of the motor housing.
5. Unscrew the screw ring.
6. Hold the cutter housing close over a plastic bowl or kitchen sink and carefully turn
the cutter housing with the outlet downwards. This way, the parts within the cutter
housing will fall out. Possibly, for this you must impress the gear of the worm shaft
in the cutter housing.

CLEANING THE APPLIANCE

WARNING!
avoid injuries.
Do not use any abrasive cleaners, cleaning pads (e.g. metal scouring pads), or any
corrosive chemicals (e.g. bleach) for cleaning the appliance or any parts of it, to
avoid damage to the surfaces. Do not immerse the motor housing or power cord in
water or any other liquid. Do not spill or drip any liquids on the motor housing, or on
the power cord to avoid risk of fire and electric shock. Do not use violence!
Do not place the appliance or any part of it in an automatic dishwasher!
1. Clean pusher, tablet, cutter housing, worm shaft, and screw ring, as well as any
used tools with warm dish-water and a nylon brush. If there are any tools within
the pusher, take the tools out first. Stubborn residues on the surfaces can be remo-
ved better by soaking in warm dishwater for some minutes.
2. Moisture a clean cloth or soft sponge with a little warm dishwater and carefully
wipe the exterior of the appliance and the power cord.
WARNING!
reach of young children.
3. Thoroughly dry the motor housing and all parts, and let dry naturally for about
half an hour out of reach of young children.
4. It is good advice to lubricate the grinding discs and cutter blade with some vege-
table oil.
All manuals and user guides at all-guides.com
The edges of the cutter blade are very sharp. Handle with care to
Always ensure that the appliance and all parts of it are out of
57