Using The Unit - Stihl HTE 60 Gebrauchsanleitung

English
Never attempt to modify your power tool in any
way since this will increase the risk of personal
injury.
Regularly check that the insulation of the power
cord and plug is in good condition and shows no
sign of ageing (brittleness).
Electrical components, e.g. power cord, may only
be repaired or replaced by a qualified electrician.
Clean plastic components with a cloth. Do not
use aggressive detergents. They may damage
the plastic.
Do not spray the machine with water.
Clean cooling air inlets in motor housing as nec‐
essary.
Observe sharpening instructions – keep the
chain and guide bar in good condition at all times
for safe and correct handling of the saw. The
chain must be properly sharpened, tensioned
and well lubricated.
Always change the chain, guide bar and sprocket
in good time.
Store chain lubricant in properly labelled, safety-
type canisters only.
Store the machine is a safe and dry place.
3

Using the Unit

3.1 Preparation
► Wear suitable protective clothing, observe
safety precautions
3.2 Cutting sequence
To allow branches to free fall, always cut the
lower branches first. Prune heavy branches
(large diameter) in several controllable pieces.
WARNING
Never stand directly underneath the branch you
are cutting – be wary of falling branches. Note
that a branch may spring back at you after it hits
the ground – risk of injury.
3.3 Disposal
Do not throw cuttings into the garbage can – they
can be composted.
3.4 Working techniques
Hold the handle housing with your right hand,
and the shaft with your left hand. Your left arm
32
should be extended to the most comfortable
position.
The shaft should always be held at an angle of
60° or less.
The least tiring working position is a tool angle of
60°.
Any lesser angle may be used to suit the situa‐
tion.
3.5 Cross-cut
To avoid pinching the bar in the cut, position the
housing against the branch and then perform the
cross-cut from the top downwards.
3.6 Relieving cut
2
1
3 Using the Unit
0458-247-9921-C