Herunterladen Inhalt Inhalt Diese Seite drucken

Cleaning; Switching Off The Machine; Cleaning The Outside Of The Machine; Cleaning The Stainless Coffee-Holders - Nuova Simonelli Aurelia II Gebrauchsanweisung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

CLEANING

8.
8.1
SWITCHING OFF
THE MACHINE
To switch the machine off press the main switch
and set the machine to the O energy position.
8.2
CLEANING THE
OUTSIDE OF THE
MACHINE
The machine must be set to "O" power (switch
off and disconnector open) before any cleaning
operations are performed.
WARNING
It is not possible to clean the machine using
water jets or standing it in water.
WARNING
Do not use solvents, chlorine-based prod-
ucts or abrasives.
Cleaning the work area: remove the worktop,
lifting it up from the front and sliding it out.
Remove the water collection dish underneath
and clean everything with hot water and cleans-
ers.
Cleaning the bottom: To clean all the chromi-
um-plated areas, use a soft, damp cloth.
8.3
CLEANING THE
STAINLESS
COFFEE-HOLDERS
The stainless coffee-holders are situated under
the delivery units, as shown in figure (29).
Fig. 28
NOTE: To clean proceed as follows:
Turn the screw placed in the centre of the
coffee-holder.
Slide the coffee-holder out and check that
its holes are not obstructed but clean.
If obstructed, clean as described (Paragraph
"CLEANING FILTERS AND FILTER-
HOLDERS")
We recommend cleaning the coffee-holder
once a week.
8.4
CLEANING THE
UNIT WITH THE
AID OF THE BLIND
FILTER
The machine is pre-set for cleaning the delivery
unit with a specific washing powder.
The machine will initiate washing cycle which
consists in the circulation of hot water followed
by regular breaks.
We recommend carrying out a washing cycle at
least once a day with special cleansers.
RISK OF INTOXICATION
Once the filter-holder has been removed,
Fig. 29
repeat delivery operations a few times to
eliminate any cleanser residues.
To carry out the washing procedure, proceed as
follows:
1) Substitute the filter with the delivery unit
blind filter.
2) Fill it with two spoonfuls of special cleanser
powder and insert it into the unit filter-holder.
3) Press one of the coffee keys and halt it after
10 seconds.
4) Repeat the procedure several times.
5) Remove the filter-holder and carry our a few
deliveries.
8.5
CLEANING
FILTERS AND
FILTER-HOLDERS
Place two spoonfuls of special cleanser in half
a litre of hot water and immerse filter and filter-
holder (without its handle) in it leaving them to
soak for at least half an hour. Then rinse abun-
dantly with running water.
CAUTION
75

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis