Setting Dipswitch; Expansions - Renson Healthbox Ii Compact Handbuch

en Healthbox
8.6 • Setting DIPswitch
* Applicable for printed circuit board V6:
Manually changing the dip switches on the
Healthbox allows the function of a control knob
to be changed;
• Dip switch 1:
(applicable for the 4-position control knob)
Dip switch 1
OFF
ON
• DIPswitch 3:
(applicable to the 4-position control knob and
the touch display)
Dip switch in position OFF:
– Automatic Breeze function is deactivated
– The manual Breeze mode cannot be activated via
the 4-position control knob. Only the Light Breeze
mode can be selected via the touch display.
Dip switch in position ON:
– Automatic Breeze function is activated
– (Full) Breeze mode can be manually activated via XVK4 or touch
display (Light Breeze mode can no longer be selected via the touch
display)
Note: The Healthbox must not be restarted after setting the dip switches
9 • Expansions
The Healthbox can be expanded to include the following applications:
• Connection to a RENSON
kitchen odours with a low discharge air flow.
• Connection to Qbus domotica system to link your ventilation system to your other devices from
the domotica system.
• Connection to RENSON
flexible silencers (Acoudec), Triple Flow, etc.
Visit our website www.renson.eu for further information
112
II (Compact) & Healthbox
®
Ventilation Mode
Empty House Mode
Light Breeze Mode
motorless extractor hood (Odormatic) for a profitable discharge of
®
air components: Air ducts (Easyflex), roof and/or facade glands,
®
Smartzone
®
Un 240V~50Hz
Imax 0.55A
XVK4
1 2 3 4
4 3 2 1 C2 D C B A C1
BUS
B A - +
INIT
SD CARD
STATUS
FB
CONFIG
RESET
INTERFACE
RENSON 019
e.g.: DIP 1 ON
Dip 3 OFF
N L
V6 = print V6