Start Calibration Process On The Main Print Board - Renson HEALTHBOX II Compact Handbuch

en Healthbox
7.10.2 • Start calibration process on the main print board
First complete the steps mentioned in section 7.10.
• The Status LED will blink red.
• Calibration procedure:
press and hold INIT-button
(>5sec.) until the Status LED
continuously lights up red.
• Feedback:
Feedback of the Status-LED:
– During calibration: lights up continuously
– During C-mode (calibration completed): no longer lights up
The feedback can also be read on the control switches (see section 8).
• The preset pressure of the ventilation unit can be displayed on the switch or touch display.
100
II (Compact) & Healthbox
®
Smartzone
®