Checking The Alarm Status - Silvercrest SBL 3 D1 Bedienungsanleitung Und Sicherheitshinweise

• Press the M button (9) several times until "AL" (14) is shown on the
display (2) and
• Press and hold the ▸II button (5) for approx. 2 seconds.
• Use the I◂◂ (8) and ▸▸I (4) buttons to select the "ON" or "OFF" option.
• Press the ▸II button (5) briefly.
• If you selected "ON", the hours flash. You can now set the hours by
pressing the I◂◂ (8) and ▸▸I buttons (4). You can keep the buttons
pressed to accelerate the digits count. Press the ▸II button (5) briefly to
apply the setting.
• The minute display flashes and you can now use the I◂◂ (8) and ▸▸I (4)
buttons to set the minutes. You can keep the buttons pressed to
accelerate the digits count. Press the ▸II button (5) briefly to apply the
setting.
• The volume indicator (10) flashes. You can now set the alarm volume
by pressing the I◂◂ (8) and ▸▸I (4) buttons. During the adjustment the
alarm sound is played at the set volume. You can keep the buttons
pressed to accelerate the digits count. Press the ▸II button (5) briefly to
apply the setting.

9.8 Checking the alarm status

The alarm status can be checked in alarm mode. Proceed as follows:
• Switch the speaker on by pressing and holding the
approx. 2 seconds.
• Press the M button (9) several times until "AL" (14) is shown on the
display (2) and
(12) or "FM" (13) goes out..
(12) or "FM" (13) goes out.
SilverCrest SBL 3 D1
button (1) for
English - 53