Radio Mode; Automatic Tuning; Manual Tuning; Recalling A Saved Station - Silvercrest SBL 3 D1 Bedienungsanleitung Und Sicherheitshinweise

9.5 Radio mode

The speaker has a radio function. Proceed as follows to use the radio
mode:
• Switch the speaker on by pressing and holding the
approx. 2 seconds.
• Press the M button (9) several times until "FM" (13) is shown on the
display (2). The frequency of the last station used (10) is shown briefly
on the display (2).

9.5.1 Automatic tuning

Start automatic tuning by pressing the ▸II button (5) and holding it down
for about 2 seconds. Any stations found are saved automatically in order
of frequency. After the station scan has finished, the first station saved is
tuned and played. You can save up to 30 stations.

9.5.2 Manual tuning

This function allows you to search for a station without saving it. Briefly
press the I◂◂ (8) or ▸▸I (4) button twice to launch the station scan in the
selected direction. The search stops at the next station found. Please note
that any station found using this method is not played after switching the
device off and back on or after toggling to a different mode.

9.5.3 Recalling a saved station

Press and hold the I◂◂ (8) or ▸▸I (4) button for approx. 2 seconds to
toggle through stored stations.
SilverCrest SBL 3 D1
button (1) for
English - 51