Repair Service; Service-Center; Importer - Parkside PRP 400 A1 Originalbetriebsanleitung

GB IE
will invalidate the warranty. Periodically
check that the float switch is operational.
Warranty and liability claims will be void
in case on non-compliance or if the pump
runs dry.
In particular, the guarantee is likewise void
in the case of employment of the sewage
water pumps without base plate or (this
applies for all pumps) in case of damages
which are caused by supporting on or sus-
pending from the mains cable. The pumps
must not be run dry or exposed to frost.
Processing in Case of Guarantee
To ensure quick handling of you issue,
please follow the following directions:
• Please have the receipt and identification
number (IAN 361098_2007) ready as
proof of purchase for all enquiries.
• Please find the item number on the rat-
ing plate.
• Should functional errors or other de-
fects occur, please initially contact the
service department specified below by
telephone or by e-mail. You will then re-
ceive further information on the process-
ing of your complaint.
• After consultation with our customer
service, a product recorded as defective
can be sent postage paid to the service
address communicated to you, with the
proof of purchase (receipt) and specifica-
tion of what constitutes the defect and
when it occurred. In order to avoid ac-
ceptance problems and additional costs,
please be sure to use only the address
communicated to you. Ensure that the
consignment is not sent carriage forward
or by bulky goods, express or other spe-
cial freight. Please send the equipment
inc. all accessories supplied at the time
of purchase and ensure adequate, safe
transport packaging.
28

Repair Service

For a charge, repairs not covered by the
guarantee can be carried out by our ser-
vice branch, which will be happy to issue
a cost estimate for you.
We can handle only equipment that has
been sent with adequate packaging and
postage.
Attention: Please send your equipment to
our service branch in clean condition and
with an indication of the defect.
Equipment sent carriage forward or by
bulky goods, express or other special
freight will not be accepted.
We will dispose of your defective devices
free of charge when you send them to us.

Service-Center

Service Great Britain
GB
Tel.: 0800 404 7657
E-Mail: grizzly@lidl.co.uk
IAN 361098_2007
Service Ireland
IE
Tel.: 1890 930 034
(0,08 EUR/Min., (peak))
(0,06 EUR/Min., (off peak))
E-Mail: grizzly@lidl.ie
IAN 361098_2007

Importer

Please note that the following address is
not a service address. Please initially con-
tact the service centre specified above.
Grizzly Tools GmbH & Co. KG
Stockstädter Straße 20
DE-63762 Großostheim, GERMANY
www.grizzlytools-service.eu