Endress+Hauser CM14 Einbauanleitung Seite 7

Kit CM44x
Mounting CM14 into existing cabinet cutout
1. Push the adapter frame frome the outside into the cabinet cutout.
 The adapter frame's clips fix it.
2. Position CM14 frome the outside into the adapter frame.
3. Push the CM14 fixing frame onto the device's back until the limit stop.
 (3a) The frame must snap into the last opening of the device housing.
4. Screw in at least the two fixing bolts supplied with the device as shown in the figure.
Hand-tighten the screws until the device is safely fixed in the cabinet cutout.
Endress+Hauser
A0021441 A0021442
Mounting
7