Balluff BTS M30E0-UUI-H0001-S04G Betriebsanleitung Seite 88

BTS M30E0-_ _ _-H0001-S04G
Infrared Temperature Sensor
15
IO-Link Interface
Teach Instructions
Two Value Teach is explained using SP1. The same sequence is applied for SP2 with the corresponding commands.
Prerequisite:
The sensor is installed, aligned and in IO-Link mode.
How to proceed:
1. Position the object within the beam path.
2. Select Teach-In-Channel as follows:
Access Index
W 0x003A
3. Teach in teach point 1 (TP1): Send system command 0x43 to the sensor.
Access Index
W 0x0002
4. Verify whether TP1 has been taught in successfully:
Read out and check the Teach-In-Status parameter using index 0x003B.
Access Index
R 0x003B
5. Remove object from detection range.
6. Teach in teach point 2 (TP2): Send system command 0x44 to the sensor.
Access Index
W 0x0002
7. Verify whether TP2 has been taught in successfully:
Read out and check the Teach-In-Status parameter using index 0x003B.
Access Index
R 0x003B
8. Save and apply switch point SP1:
Send system command 0x40 to the sensor.
Access Index
W 0x0002
9. Verify whether SP1 has been applied successfully:
Read out and check the Teach-In-Status parameter using index 0x003B.
Access Index
R 0x003B
40
english
All manuals and user guides at all-guides.com
Value Meaning
0x00 Standard BDC (BDC1)
0x01...0x02 BDC1...BDC2
0xFF All BDC
Value Meaning
0x43 SP1 Two Value Teach TP1
Value Meaning
0x14 TP1 for SP1 was successfully taught
Teach-In State = WAIT FOR COMMAND
0x07 Teach-In State = ERROR
Value Meaning
0x44 SP1 Two Value Teach TP2
Value Meaning
0x34 TP1 and TP2 successfully taught in from SP1
Teach-In State = WAIT FOR COMMAND
0x07 Teach-In State = ERROR
Value Meaning
0x40 Teach Apply
Value Meaning
0x01 SP1 successfully applied
Teach-In State = SP1 SUCCESS
0x07 Teach-In State = ERROR
Result
Go to step 5
Return to step 3
Result
Go to step 8
Return to step 3
Result
Teach-in ended successfully
Return to step 3