Device Configuration - Endress+Hauser RIA14 Bedienungsanleitung

Operating the field indicator
• In the Comm DTM settings, set the baud rate to 2400 baud and select the COM-port used.
• Add the RIA14/16 Version Vx.xx.xx device DTM to the project using the "Add device..."
function.
!
Note!
Online configuration is not possible with the RIA14/RIA16.
• To then configure the device itself, follow these Operating Instructions for the device. The
entire Setup menu, i.e. all the parameters listed in these Operating Instructions, can also be
found in the FieldCare Device Setup.
Fig. 12: Configuring the field indicator via interface adapter
!
Note!
In general, it is possible to overwrite parameters with the FieldCare PC software and the
appropriate device DTM even if access protection is active.
If access protection by means of a code should be extended to the software, this function should
be activated in the extended device setup.
5.5

Device configuration

Detailed information on device configuration can be found in the operating instructions on the
CD-ROM which is delivered along with the device.
38
RIA14
a0011264-en
Endress+Hauser