Steinbach Poolrunner APPcontrol Originalbetriebsanleitung Seite 42

Fault description
1H+2H+3H blink rapidly and a
buzzing sound is heard
ALL+1H blink rapidly and an alarm
is heard
WALL+2H blink rapidly and a
buzzing sound is heard
FLOOR+3H blink rapidly and a
buzzing sound is heard
ALL+WALL+1H+2H blink rapidly and
an alarm is heard
WALL+FLOOR+2H+3H blink rapidly
and a buzzing sound is heard
WALL+FLOOR+2H+3H blink rapidly
and an alarm is heard
WALL blinks rapidly and an alarm is
heard
The cable is twisted or tangled.
The device cannot reach all spots.
42
Cause
Seal of the motor unit is not leak-
tight.
Pump is overloaded.
Drive motor 1 is overloaded.
Drive motor 2 is overloaded.
There is abnormal voltage in the
device.
Device is out of the water.
Device is out of the water and could
not be restarted.
Device has toppled over.
The cable was not completely
detached.
The cable in the water is too long.
The device becomes stuck on the
drain grate.
The control unit was wrongly
positioned.
The water circulation of the pool is
switched on.
The cable is too short.
Remedy
Stop the device and contact
customer service.
Stop the device and check the wheel
and the pump.
Check the drive belt.
Check the drive belt.
Stop the device and contact
customer service.
Stop the device, immerse it in water
and start the device again.
Stop the device, immerse it in water
and start the device again.
Manually set the device straight
again.
Switch off the device, disconnect the
cable and untangle it.
Pull the excess cable length out of
the water. The cable in the water
should only be long enough so that
the device can reach all spots in the
pool.
Switch off the filter system of the
pool.
Position the control unit so that the
device can easily access all spots.
Switch off the filter system of the
pool.
Let a sufficient length of cable into
the pool so that the device can
reach all spots in the pool. Observe
the minimum distance of the control
unit to the pool.