Storage; Troubleshooting - Steinbach Poolrunner APPcontrol Originalbetriebsanleitung

3. Thoroughly rinse the filter unit with plain tap
water.
4. Close the rear cover.
5. Slide the latch into the "Closed" position.
The filter units are cleaned.

Storage

1. Thoroughly clean the device (see section "Cleaning").
2. Let all parts dry completely.
3. Then store the device and its accessories in a dry and frost-free place (≥ +5 °C) without direct
sunlight.

Troubleshooting

Fault description
1H blinks rapidly and an alarm is
heard
All LEDs blink rapidly and a buzzing
sound is heard
15
16
17
Cause
The device is no longer in the water.
Mains adapter is overloaded.
Remedy
Place the device in the water again
or wait until the device restarts
automatically.
Contact customer service.
41