Setting The Time - AEG DDLE ÖKO TD 18 Bedienung Und Installation

Operation – for users and qualified contractors
4.2.8 Selecting second line of display
Reset consumption display "Energy consumption and water volume" to zero.

4.2.9 Setting the time

4.2.10 Wireless remote control - scan / - log on / - log off
Wireless remote control - scan at appliance
Wireless remote control - log on to appliance
Wireless remote control - log off appliance
4.3 Resetting to factory settings
Anti-scalding protection and self-learning wireless remote control are not reset.
Factory settings (see chapter "Specification").
4.4 Wireless remote control operation
Wireless remote control operation
OFF
3s
You can switch the appliance heater to OFF using the mini wireless remote control. To do so, press and hold the minus key
for ≥ 3 seconds. Press any key to switch it back on.
28
»
Hold down ECO for three seconds.
»
Briefly press ECO several times.
»
Select display value of second line:
l/min Flow rate
kWh Energy consumption
m³ Water volume
Clock Time
»
Press keys 1 and 2 in the INFO menu
simultaneously when the corresponding
consumption value is shown on the display.
»
Hold down ECO for three seconds.
»
Briefly press ECO several times.
»
Select the time.
»
Hold down ECO for three seconds.
»
Briefly press ECO several times.
»
Hold down ECO for three seconds.
»
Briefly press ECO several times.
»
Press key 1; self-learning phase is enabled.
»
Press any key on the wireless remote control.
»
Hold down ECO for three seconds.
»
Briefly press ECO several times.
»
Press key 2 in "rc" mode.
»
Hold down keys 1 and 2 simultaneously for two
seconds.
»
Press 38°
»
Press 55°
»
Press +
»
Press -
38 °C
Selected display.
0
38 °C
For example 12:15
Note:
Reset the time after a power interruption.
38 °C
rc 1 ... 4: Number of wireless remote controls that are
logged on (rc: remote control).
38 °C
rc 1.
Bar graph indication runs.
rc 2: Bar graph indication extinguishes; wireless
remote control recognised.
38 °C
rc 2.
rc 0: All wireless remote controls logged off.
38 °C
Display flashes to confirm.
38 °C
55 °C
Press once: Set value raised by 0.5 °C.
Press once: Set value lowered by 0.5 °C.