AEG DDLE ÖKO TD 18 Bedienung Und Installation Seite 25

Second line of display
You can select what other information should be shown
on the second line of the display (see chapter "INFO menu
settings"):
l/min Flow rate
kWh Energy consumption *
m³ Water volume *
Time Time **
* You can reset the values of these consumption
displays to zero.
** The clock has to be reset after a power interruption.
Anti-scalding protection
Your contractor can set a permanent temperature limit
(see chapter "Customer service mode") to prevent any
water being drawn from the appliance at temperatures
that could lead to a risk of injury.
Air detection
The appliance is equipped with an air detector that
largely prevents damage to the heating system. If, during
operation, air is drawn into the instantaneous water
heater, the equipment shuts down the heating load for
one minute, thereby protecting the equipment.
Operation – for users and qualified contractors
25