Equipment Description; Equipment Layout - AEG DDLE ÖKO TD 18 Bedienung Und Installation

8. Equipment description

The bare wire heating system is suitable for soft and hard
water areas (see chapter "Specification").
8.1

Equipment layout

1 Rotary selector with keys and display
2 Appliance cap
3 Lower section, back panel
4 DHW compression fitting
5 Cold water compression fitting
6 Top, back panel
7 Electronics
8 Coding card for output changeover to 18, 21 or 24 kW (on
appliances with output selection)
9 Plug-in position for the temperature selector cable
10 Safety pressure limiter (AP 3) with reset button
11 Mains terminal
12 Knock-out for power supply from above
13 Fixing toggle
14 Outlet sensor
14
15
16
17
18
2
1
19
Installation – for qualified contractors
5
4
20
3
21
22
23
38°
OFF
3s
24
55°
25
28
15 High limit safety cut-out (STB) with reset button
16 Heating system
17 Flow sensor
18 Temperature selector plug "set T"
19 Type plate
20 Mounting bracket
21 Stud for mounting bracket
22 Cable grommet (power cable from above/below)
23 Twin nipple 2 x (cold water with shut-off valve)
24 Flat packing
25 Screws, rawl plugs for securing the lower back panel
26 Operating and installation instructions
27 Installation template
28 Wireless remote control FBM Comfort
13
12
11
10
9
8
7
6
27
26
31