Units Of Measurement; General Information; Safety; Correct Use - AEG DDLE ÖKO TD 18 Bedienung Und Installation

OPERATION

1. General information

The chapters „Special Information" and „Operation" are
intended for both the user and qualified contractors.
The chapter „Installation" is intended for qualified con-
tractors.
Note
Read these instructions carefully before using the
appliance and retain them for future reference.
Pass on the instructions to a new user if required.
1.1

Safety instructions

1.1.1 Structure of safety instructions
KEYWORD Type of risk
!
Here, possible consequences are listed that may re-
sult from failure to observe the safety instructions.
» Steps to prevent the risk are listed.
1.1.2 Symbols, type of risk
Symbol Type of risk
Injury
!
Electrocution
Burns
(burns, scalding)
1.1.3 Keywords
KEYWORD Meaning
DANGER Failure to observe this information will result in seri-
ous injury or death.
WARNING Failure to observe this information may result in seri-
ous injury or death.
CAUTION Failure to observe this information may result in
non-serious or minor injury.

1.2 Other symbols in this documentation

Note
General information is identified by the symbol
shown on the left.
» Read these texts carefully.
Symbol Meaning
Material losses
!
(appliance damage, consequential losses and envi-
ronmental pollution)
Appliance disposal
» This symbol indicates that you have to do something.
The action you need to take is described step by
step.
Operation – for users and qualified contractors

1.3 Units of measurement

Note
All measurements are given in mm unless stated
otherwise.

2. Safety

2.1 Correct use

This appliance is designed for domestic use. It can be
used safely by untrained persons. The appliance can also
be used in a non-domestic environment, e.g. in a small
business, as long as it is used in the same way.
This appliance is a pressure appliance for the heating of
cold water to DIN 1988 that can supply one or several
draw-off points. The appliance is suitable for reheating
preheated water up to 45 °C. The maximum permissible
supply temperature is 60 °C. The appliance can be
damaged at higher temperatures. "Error" is displayed from
45 °C. With the "central thermostat" (see chapter "Special
accessories"), the maximum supply temperature can be
limited to 60 °C.
Any other use beyond that described shall be deemed
inappropriate. Observation of these instructions is also
part of the correct use of this appliance. Any changes or
modifications to this appliance void all warranty rights.
2.2 Safety instructions
Observe the following safety information and instructions.
All steps up to the commissioning of this appliance must
only be carried out by qualified contractors.
The contractor is responsible for adherence to all
currently applicable regulations during installation and
commissioning.
Operate this appliance only if it is fully installed and all
safety equipment is fitted.
Note
wireless remote control is supplied with power by a
circular lithium battery.
Remove spent batteries. Leaking batteries result in
damage which is excluded from any warranty.
Never install rechargeable NiCad batteries.
Risk of scalding!
There is a risk of scalding at outlet temperatures in
excess of 43 °C.
WARNING Injury
!
The appliance may be used by children aged 8 and
up and persons with reduced physical, sensory or
mental capabilities or a lack of experience provided
that they are supervised or they have been instruct-
ed on how to use the appliance safely and have un-
derstood the resulting risks. Children must never
play with the appliance. Children must never clean
the appliance or perform user maintenance unless
they are supervised.
CAUTION Risk of burns!
If operating with preheated water, e.g. from a solar
thermal system, the DHW temperature may vary from
the selected set temperature.
23