Mounting - LIVARNO LUX LSLB 100 A1 Bedienungsanleitung Und Sicherheitshinweise

LIVARNO LUX LSLB 100 A1

6.4 Mounting

The LED emitter (1) must be wall-mounted.
Before mounting, make sure that the cable to
which the product is to be connected is not live.
To do this, remove the fuse or switch the circuit
breaker in the fusebox off (0 position).
Remove the mounting bracket (9) by undoing
the screws (6) on both sides with an open-jawed
spanner and twist them out anticlockwise
together with the snap rings and washers.
Choose the mounting position on the wall. Use
the mounting bracket (9) as a template and
draw the position of the drill holes on the wall
through the long holes. Drill the holes in the wall.
Fit the rawlplugs (11) into the holes you have
drilled and screw the mounting bracket (9) to
the wall using the screws (12).
26 - English