Tools Required; Before Mounting - LIVARNO LUX LSLB 100 A1 Bedienungsanleitung Und Sicherheitshinweise

6.2 Tools required

The following tools are not supplied. This list is a guide only. The actual tools you will require depend on
the individual location.
 Ladder
 Voltage tester
 Spirit level, folding rule, pencil
 Drill with 8 mm stone/concrete bit
 Phillips screwdriver, flat screwdriver
 Open-jawed spanner (gap 12 mm), combination pliers, wire cutters

6.3 Before mounting

DANGER! The unit must only be mounted by an authorised electrical engineer! The power
supply must be via the building's electrical circuit.
DANGER! The power must be switched off during the mounting process!
WARNING! When drilling holes, make sure there are no cables in the walls.
 Before mounting the LED emitter (1), make sure you are familiar with all its individual parts and read
and observe the instructions and diagrams in these operating instructions.
 Make sure that the cable to which the LED emitter (1) is to be connected is not live. To do this, remove
the fuse for the relevant power circuit or switch the circuit breaker to the "0" position in your fusebox.
 Make sure that you also test that the cable is not live using a voltage tester!
LIVARNO LUX LSLB 100 A1
English - 25