Mounting; Mounting The Solar Panel - LIVARNO LUX 898-S Bedienungs- Und Sicherheitshinweise

with plenty of clean water and seek medical
advice immediately!
WEAR PROTECTIVE GLOVES!
„
Leaking or damaged (rechargeable)
batteries can cause chemical burns if
they come into contact with skin� Please wear
suitable protective gloves�
In the event that a battery leaks, remove it from
„
the product immediately to avoid damage�
z Mounting
Please note: Remove all packaging material�
Before you start, please select a suitable location
for mounting the product� Ensure that you will not
come into contact with electricity, gas or water
pipes when drilling into the wall� Use an electric
drill to drill the holes into the masonry� Observe all
safety instructions provided in the operation and
safety manual for your drill� Otherwise there is a
risk of death or injury from electric shock�
Consider the following aspects when
choosing the position of the spotlight:
Ensure the product illuminates the desired area�
„
Ensure the motion sensor
area
(see figures B and C).
The motion sensor has a detection area of up to
„
8 m and a detection angle of approx� 100°�
Ensure that the motion detector
„
illuminated by street lighting at night� This may
impair its function (see figures B and C).
The recommended mounting height is 2 to 4 m�
„
Use the mounting holes
„
mount to mark the position of the drill holes
16
(see figure F).
Drill the holes (ø 6 mm)�
„
Now insert the wall plugs
„
holes (see figure F).
Lift the wall bracket
„
and attach it lightly using the screws
figure F).
Tighten the screws
20
„
align the LED Solar Spotlight
and F)�
10
GB/CY
covers the desired
6
is not
6
in the spotlight's wall
17
into the drilled
19
to the mounting position
16
(see
20
in the mounting holes and
(see figures C
21
The LED Solar Spotlight
„
pushed onto the wall bracket (see figure C).
Aligning the LED Solar Spotlight
The reflectors can be adjusted vertically (left/
5
right) in an angle of up to 65°, and horizontally in
an angle of 65° (upwards) and 70° (downwards)
respectively. Align the reflectors as desired. Now
use the fixing bolt
7
reflectors �
5
Then align the motion detector
faces your desired detection area (see figure B).
Please note: The motion sensor covers a
detection angle of up to 100°�

Mounting the solar panel

You can choose to mount the solar panel directly
to the spotlight, to an even surface (wall/roof) or,
for example, on the lawn, using the ground spike
that is included in delivery�
Please note: The solar panel
sunlight� Even partial shade during the day can
significantly impair the charging process of the
solar panel (see figure A).
1
Cardinal point:
The optimum alignment is south� A slight deviation
to the west should be chosen over a deviation to
the east�
Mounting the solar panel to the spotlight
Attach the solar panel's bracket
panel / spotlight holder
sleeve , tightening it by hand (see figure A).
22
Now attach the solar panel / spotlight holder
by inserting the guide bar
the guide holes of the LED Solar Spotlight
23
until they lock in place (see figures A, B and C).
Please note: To dismount the holder, very
carefully press the tabs on the sides until the
holder is released�
Now plug the supply line
socket (remove the rubber cover to do so) and
9
push the socket over the plug (see figures A and
C)�
can now be easily
21
to fasten and connect the
, ensuring that it
6
requires direct
1
to the solar
2
using the connecting
3
of the holder into
24
into the charging
4
3
21