Getting Started; Aligning The Movement Sensor (2); Adjusting The Light Time (Time); Adjusting The Sensor Sensitivity (Sens) - LIVARNO LUX LSLB 100 A1 Bedienungsanleitung Und Sicherheitshinweise

LIVARNO LUX LSLB 100 A1

7. Getting started

7.1 Aligning the movement sensor (2)

Make sure there are no movements which are not to be detected within the detection range of
the movement sensor (2) (e.g. pavements, roads).
The best time to set the light sensitivity for the movement sensor (2) is when the lighting conditions
are the same as they will be when the LED emitter (1) is active.
Twisting the sensor housing (10) makes it easier to adjust the controllers for "TIME" (3), "LUX"
(4) and "SENS" (5). Please also note the illustration [C] on the cover page.
• Adjust the movement sensor (2) so it covers the area you want as best possible. It must not be blocked
by objects or similar.
• You can align the movement sensor (2) horizontally or vertically by twisting and tipping the sensor
housing (10).

7.2 Adjusting the light time (TIME)

You can adjust the light time using the TIME controller (3) on the sensor housing (10) (approx.5 seconds.
to 5 minutes). Turn the TIME controller (3) in the + direction to increase the light time and in the - direction
to reduce the light time.

7.3 Adjusting the sensor sensitivity (SENS)

You can adjust the sensitivity using the SENS controller (5) on the sensor housing (10). Turn the SENS
controller (5) into the + direction to increase the sensitivity or turn it to the - direction to reduce the
sensitivity. The higher the sensitivity, the greater the detection range (8 m maximum).

7.4 Adjusting the light sensitivity (LUX)

You can adjust the light sensitivity using the LUX controller (4) on the sensor housing (10). This allows you
to define the light conditions in which the lighting sensor reacts and the LED emitter switches on or off.
Twist the LUX controller (4) in the
conditions.
Turn the LUX controller (4) in the
relatively poor light conditions.
30 - English

direction if you wish the movement sensor (2) to react in brighter

direction if you only wish the movement sensor (2) to react in