Parkside PSA 25 B1 Kurzanleitung Seite 16

5 Operation
5.11 Unravelling the hose
Pull the irrigation hose
to the desired length (see fig. J).
3
Allow the hose to follow. The irrigation hose
will go back a short distance until it is held
5
by the retraction block.
Open the tap. Ensure that the spray nozzle
is closed.
Open the spray nozzle
right (see fig. K).
The red marking on the hose signifies that you
are coming to the end of the hose. From here,
the hose can only be pulled out a few more cm.
5.2 Re-ravelling the hose
Risk of injury and damage! If the irrigation
hose is not guided, the spring tension of the au-
tomated ravelling system can cause it to spin
around and lead to injury and property damage.
Always guide the irrigation hose by hand. Ensure
that no other people are nearby when re-ravel-
ling.
Never reach inside of the housing.
Close the spray nozzle
left (see fig. K).
Close the tap.
Open the spray nozzle
pressure. Turn the spray nozzle
to do so. Close the spray nozzle
turning it to the left.
Hold the irrigation hose
. Pull briefly on the irrigation hose
7
lease the retraction block. Guide the irrigation
hose by hand while it automatically rolls up
5
to the limit stop
4
fig. L).
Swivel the hose box
save space (see fig. B).
16 GB/IE
out of the hose box
5
by turning it to the
7
by turning it to the
7
to release the water
7
to the right
7
again by
7
by the spray nozzle
5
to re-
5
into the hose box (see
3
towards the wall to
3
7