Telecom Behnke 10-Serie Anleitung Seite 55

All manuals and user guides at all-guides.com
Problem
Changed settings
were not saved
www.behnke-online.com
Cause
Set-up mode was not enabled
Configuration step not terminated
with the # key
Improper value set or wrong but-
ton pressed
Set-up mode terminated due to
inactivity for 30 seconds
Instructions for Series 10
Dimensioning
Action
Enter set-up mode and then enter
the configuration steps
Most configuration steps require
to be terminated by entering the
# key.
Entering improper values or
pressing wrong buttons will result
in the Behnke Series 10 Intercom
station terminating your entry
and producing an error tone.
Afterwards you may start over
again and try to correctly enter the
configuration required.
Your Behnke Series 10 Intercom
station will terminate set-up
mode after 30 seconds without
any entry. To enter additional
configurations, please start over
by entering set-up mode.
GB
55