Initial Start-Up; Charging The Battery; Remove/Insert Battery; Assembling/Dismantling The Blowpipe - Parkside PLSA 40-Li C2 Originalbetriebsanleitung

may impair the functionality
of active or passive medical
implants. In order to reduce
the danger of serious or fatal
injuries, users who wear medi-
cal implants must consult their
doctor and the manufacturer
of the implant before operat-
ing the machine.

Initial start-up

Before operating the device, you must
- insert both rechargeable batteries,
- install the blower or suction pipes,
- install the collection bag for suctioning
leaves,
- insert the protective cover for leaf
blowing.
The cordless leaf vacuum/blower
has a safety contact, which is
located in the motor housing (
1), where the protective cover (
7) or the suction pipe (
is mounted.
are not activated, the de-
vice cannot be started!
Pay attention to the correct assembly
- protective cover (7) for blowing
mode;
- suction pipe (16) for vacuum
mode.
Caution! Risk of injury! Dur-
ing the assembly or disas-
sembly of the blowpipe,
suction pipe, protective cover
or collection bag, the device
must be turned off and all
moving parts must have
come to a standstill. Remove
the batteries before carrying
out any work!
If these contacts

Charging the battery

Ensure that the ambient tem-
perature does not exceed
40 °C or fall below 4 °C dur-
ing the charging process.
If warm, allow the battery to cool
before charging.
Do not expose the battery to direct
sunlight for long periods and do
not place it on a radiator (max.
50°C).
1. Remove the rechargeable batteries (5)
from the device, if necessary.
2. Slide the rechargeable batteries (5)
onto the charger (6) up to the stop.
3. Plug the charger (6) into a socket.
4. Once charging is complete, disconnect
the charger (6) from the mains supply.
5. Remove the battery (5) from the
charger (6).
16)

Remove/insert battery

1. To remove the battery (5) from the de-
vice, press the release button (5.1) on
the battery (5) and pull the battery out.
2. To insert the battery (5), push the bat-
tery (5) along the guide rail into the
device. You will hear it click into place.
Only insert the battery once
the battery-operated tool is
fully ready for use.
Assembling/dismantling
the blowpipe
Never use the leaf blower
with only one blowpipe sec-
GB IE
33