Parkside PLSA 40-Li C2 Originalbetriebsanleitung Seite 29

• Carefully inspect the surface
to be cleaned and remove all
wires, stones, cans and other
foreign bodies.
• Use a rake or broom to remove
foreign bodies before beginning
the blowing/suction process.
• Use both parts of the blowpipe
so that the airflow can work
close to the ground.
• In very dry conditions, lightly
moisten the surface or use a
sprayer to reduce the build-up of
dust.
• Do not work with a damaged or
incomplete device or one which
has been converted without the
permission of the manufacturer.
Before use, check the safety
status of the device, in particular
the mains cable and the switch.
• Only use the device when fully
assembled.
• Only use the device in suction
mode if the collection bag is at-
tached.
Check the collection bag regu-
larly for wear or damage.
• Never operate the device with
defective protection equipment
or faulty protection covers or
without any protection equip-
ment.
• Please be aware that the op-
erator or user is responsible for
accidents or injuries to other
people or their property.
• Avoid wearing loose clothing,
clothing with hanging laces or
ties.
• Operate the machine in a rec-
ommended position and only
when standing on a solid, flat
surface.
• Do not operate the machine on
a paved surface or a gravel sur-
face where the ejected material
could cause injury.
• Always perform a visual inspec-
tion prior to use to make sure
that the shredding machine
(including its bolts) and other
fastening equipment are se-
cured, and that the housing is
undamaged and the protective
equipment and shields are pre-
sent. Replace worn or damaged
components in sets to ensure
balance. Replace damaged or
illegible markings.
Operation:
• Do not switch on the device if it
is held upside down or is not in
operating position.
Avoid starting the device unin-
tentionally. Make sure that the
device is switched off before
you pick it up or carry it.
Having your finger on the switch
of the device while carrying it
can cause accidents.
• Never point the device at others,
and in particular, do not point
the air jet at the eyes and ears
during operation.
• Always ensure secure position-
ing, particularly on slopes, when
working. Always hold the device
tightly with both hands and only
work with a correctly adjusted
carrying strap.
• Do not stretch too far and do
not lose your balance.
• Keep fingers and feet away
from the suction pipe aperture
GB IE
29