MR TAPCON 230 Montageanleitung Seite 38

6 Mounting
► Position the cable shielding, screw into place using the shield clamp pro-
vided and provide strain relief (using a cable tie).
Figure 22: Shield clamp and strain relief
6.4.4.2 Mounting terminating resistor of CAN bus
If you want to operate the device in parallel operation, you need to mount a
120 Ω terminating resistor at both ends of the CAN bus.
Figure 23: Terminating resistor of the CAN bus
► Mount terminal resistors in pins 10, 9 and 8 of the COM-X6 connector.
®
38 TAPCON 230 7820658/02 EN Maschinenfabrik Reinhausen GmbH 2021