Scheppach hmc 3200 ci Original Anleitungen Seite 31

Documentation
Planing – planing shaft protection
Fig.„I„
While planing up to 75mm workpiece thickness, the planing
shaft protection has to cover from above the workpiece and
the planing shaft. At a workpiece width of more than 75mm,
adjust the check rail of the planing shaft protection up to the
width of workpiece. Pay attention to put your hands on the
workpiece with adjacent thumbs.
1 trimming stopper
2 planing shaft protection
Joining
Fig. „J„
Use for this working cycle the trimming stopper, let the
planing shaft protection rest on the trimming desk and adjust
the check rail up to the width of workpiece.
Press the workpiece against the planing stopper and lead it
now with both hands over the planing shaft. As soon as the
board reaches far enough into the removal desk, place your
hand on it and push it without a halt over the knife shaft.
Planing – particle ejection
Fig. ''K"
While planing the trimming desk has to be locked.
Plug on the exhaust line onto the exhaust hood.
In connection with an exhaust device then can be sucked off.
Diameter of the exhaust standpipe 100mm
9322 0311
Thickness planing – machine adjustment
Pull up the desk locking device and swing open the trimming
desk.
Position the height adjustment at the trimming desk to full
height.
Swing up and lock the ejection hood (arrow).
Plug on the exhaust standpipe and tighten the wing nut.
In connection with an exhaust device then can be sucked off.
Always pay attention to, that the limit switch unit is free of dirt
and particles.
Thickness planing – desk adjustment
Fig. ''L1"
The height of the thickness desk is adjustable by means of
the hand wheel.
The integrated display of the position shows the passage
height of 5-180 mm (hms/hmc3200ci) and 3-140 mm
(hmc2600ci/hms260ci).
One hand wheel turn corresponds to 2 mm.
Keep the thickness desk and the trimming desks always free
of resin.
Clamping thickness max. 5 mm. (hms/hmc3200ci,
hmc2600ci) and 3 mm (hms260ci)
The graduation marks of the scale ring make possible a
fine adjustment, at which 1graduation mark corresponds
to 0, 05 mm (hms/hmc3200ci/hmc2600ci) and 0,057 mm
(hms260ci).
Scale correction
The thickness scale can be corrected at measuring inaccuracy.
Example: (hms/hmc3200ci, hmc2600ci)
The passage height is adjusted to 100 mm.
The processed workpiece has a measure of 101 mm.
Loosen the mounting screws of the thickness scale.
Adjust the thickness scale to the measure 101 mm.
Tighten the mounting screws of the thickness scale.
Keep the thickness desk and the trimming desks always free of
resin.
Thickness planing - feed
Fig. ''M"
The feed can be switched on and off with the lever (1).
0 = OFF
1 = ON
First switch on the feed, then set-in the workpiece.
Page:31