Annual Maintenance - SHERCO 250 SE RACING Bedienungsanleitung

MAINTENANCE SCHEDULE

ANNUAL MAINTENANCE

MAJOR MAINTENANCE ITEMS THAT SHOULD BE PERFORMED BY THE DEALER
Fork
Shock
Clean and grease steering head bearings and seals
Replace fiberglass in the muffler
Treat electric contacts and switches with an aerosol protector
Replace the clutch hydraulic fluid
Replace the brake fluid
CHECKS AND MAJOR MAINTENANCE TO BE PERFORMED BY THE RIDER
Check the engine oil level
Check brake fluid level
Check status of the brake pads
Verify operation of the lights
Verify operation of the horn
Lubricate throttle cable
Regularly purge the air from the fork legs
Regularly clean the fork dust seals
Clean and lubricate chain, check tension and adjust if necessary
Clean air filter and box
Check tires and tire pressure
Check the coolant level
Check fuel lines for leaks
Check status of all the controls
Check the brakes
Spray anti-corrosion protector on all non painted parts (except for the brake parts and the exhaust system)
Spray protector on electrical switches
Check tightness of nuts, screws and clamps
WARNING
Check the tightening of the screws of your bike after the first ride / the first hours of use.
In competition you have to perform the 20 hour maintenance schedule after each race!
This should not be exceeded by more than 2 hours.
The services performed by the Sherco dealer do not replace routine service and maintenance by the rider!
144
Au moins 1X par an
Before After
each use each use