Adjusting The Headlight Beam; Replacing The Motorcycle Computer Battery - SHERCO 250 SE RACING Bedienungsanleitung

ELECTRICAL SYSTEM MAINTENANCE

ADJUSTING THE HEADLIGHT BEAM

1

REPLACING THE MOTORCYCLE COMPUTER BATTERY

2
The headlight beam is adjusted with the motorcycle
in a state of operation with its driver seated on the
saddle.
To set the headlight beam, tighten or loosen the
screw at the base of the headlight housing.
Tightening the screw
Loosening the screw
1. Remove the headlight housing ( p.139).
2. Remove the turn
the motorcyle computer screws.
3. Remove the screws
to get it out of the way.
1
4. Disconnect the main connector from the computer.
5. Open the dashbord with a coin.
6. Install a new battery (with the marking up).
Computer battery CR 2032
7. Replace the cover, taking care not to damage the
O-ring.
8. Plug the main connector into the computer.
9. Install it on the bike and check to make sure the
meter works.
10. Reinstall the computer support.
11. Install screws
12. Replace the headlight housing ( p.140).
13. Set the computer ( p.99).
raises the headlight beam.
1
lowers the headlight beam.
1
signal flasher in order to access
1
and remove the computer
2
and replace the turn signal flasher.
2
1
3A
141