Filling The Front Brake Reservoir With Brake Fluid; Adjusting The Position Of The Rear Brake Pedal; Checking The Travel Of The Rear Brake Pedal - SHERCO 250 SE RACING Bedienungsanleitung

BRAKES

FILLING THE FRONT BRAKE RESERVOIR WITH BRAKE FLUID

ADJUSTING THE POSITION OF THE REAR BRAKE PEDAL

CHECKING THE TRAVEL OF THE REAR BRAKE PEDAL

134
1
2
3
A
2
1
1
A
WARNING
- The hydraulic fluid is highly corrosive.
- It can be dangerous to the skin.
- Read the recommendations on the container.
- Remove the two screws
Remove the cover and the membrane
2
Fill the tank with brake fluid to the correct level
Level of brake fluid below the top
of the reservoir.
®
Motul RBF 700 brake fluid DOT4
- Reinstall the membrane, the cover and the screws.
The position of the brake pedal can be adjusted as
follows: loosen the lock nut
screw to obtain the desired position.
2
Tighten the lock nut when the pedal is properly
located.
Brake pedal lock nut
Check the pedal travel (
- Remove the spring
1
- Operate the pedal several times.
Rear brake pedal travel
- Replace the spring .
1
If the travel does not meet the specification, refer to
the rear brake travel adjustment.( p.135).
.
1
.
3
5mm
loosen or tighten the
1
M6 10Nm
below).
.
≥3mm ≥5mm
A
.
A