Rebound Damper; Setting The Riding Sag; Setting The Rear Shock Sag - SHERCO 250 SE RACING Bedienungsanleitung

ADJUSTING THE CHASSIS

REBOUND DAMPER

1

SETTING THE RIDING SAG

SETTING THE REAR SHOCK SAG

118
The adjusting screw determines the Shock
1
rebound behavior. Turning the screw clockwise
increases the hydraulic force (and vice versa).
Turn the screw clockwise to the stop then go
1
back the number of clicks required.
REAR SHOCK KAYABA
Rebound damping
With the bike on an appropriate stand
Measure the dimension R1 between a fixed point on
the chassis and the rear axle.
With the bike setting on its wheels
Measure the dimension R2 from the same fixed point
on the chassis and the rear axle. The static deflection
is the difference between R1-R2.
Static deflection
If the static deflection is not correct, adjust the preload
of the shock ( p.119).
With the rider on the motorcycle
Measure the dimension R3 between the same fixed
point on the chassis and the rear axle.
The sag is the difference between R1-R3.
Sag
If the sag is not correct, change the spring ( p.119).
Comfort 15 clicks
Standard 13 clicks
Sport 11 clicks
35mm-40mm
95mm-100mm