Removing The Rear Shock; Reinstalling The Rear Shock - SHERCO 250 SE RACING Bedienungsanleitung

CHASSIS MAINTENANCE

REMOVING THE REAR SHOCK

1
3

REINSTALLING THE REAR SHOCK

2
3
128
2
4
1
3
Place the motorcycle on a suitable stand.
Remove the right side plate.
Remove the screws and
1
ATTENTION
Do not remove the muffler after operating the motorcycle.
It can behot and there is a risk of being burned.
Remove the shaft .
3
Remove the screw .
4
Remove the top screw of the shock.
Remove the shock from the top.
Install the shock from the top.
Install the top screw and tighten.
Upper shock
M10
screw
Position the rods and "H" link.
Install the lower shock screw
Lower shock
M10
screw
Install the lower shock shaft
Link axle
Reassemble the exhaust, the 2 springs and the 2 bush.
Reassemble the rear silencer and tighten screws
using the nylock self-locking nuts.
Chassis screws
Install right side plate.
Remove the bike from the stand.
and the muffler along.
2
®
Loctite
50Nm
2701
and tighten.
1
®
Loctite
50Nm
2701
and tighten.
2
M12 60Nm
3
M6 10Nm