Reinstalling The Battery; Charging The Battery - SHERCO 250 SE RACING Bedienungsanleitung

ELECTRICAL SYSTEM MAINTENANCE

REINSTALLING THE BATTERY

1

CHARGING THE BATTERY

138
- Insert the battery into place.
- Connect the positive cable to the battery.
- Connect the negative cable to the battery.
- Install the battery retaining bracket and tighten the
two screws .
1
Chassis screws
- Check the positioning of the battery cables to make
sure that they do not interfere with the installation
of the air filter.
- Replace the air filter ( p.121).
- Replace the sea ( p.120).
The battery is a maintenance-free type. If the vehicle
is not used for an extended period, it is recommended
that the battery be disconnected and stored in a dry
place. See removing the battery ( p.137).
Check the voltage of the battery with a voltmeter:
Battery voltage
If the voltage is below the specification, remove the
battery and recharge it using a battery charger.
Factory version need a specific lithium charger.
Battery charging
(12V)
Disconnect the charger after charging.
Install the battery ( above).
M6 10Nm
>12.5V
0.5 A for 10 hours
or 5A for 30 minutes