Continuous Flow - WimTec Smart Betriebsanleitung

EN
SMART
Configuring the functions

Continuous flow:

DIP switch 3
Enable the continuous flow function to fill the washbasin or a container.
'ON' position: Continuous flow function is enabled.
'OFF' position: Continuous flow function is disabled (default setting).
Enable continuous flow
Approach the infrared sensor
with your hand. The sensor
LED starts flashing. After
flashing three times, conti-
nuous flow is enabled for the
water arrest time configured.
18 Washbasin fitting
Enable continuous flow if
cleaning stop is enabled (DIP
2, 3 = ON)
Approach the infrared
sensor with your hand. The
sensor LED starts flashing.
After flashing five times, the
cleaning stop is enabled. You
can enable the continuous
flow function by approaching
the sensor three times again
within 5 s.
3 x
WimTec SMART
5 x + 3 x
ON
OFF
1 2 3 4 5 6
Disable continuous flow
The function automatically
ends after the water arrest
time set at control 3 has
elapsed.
To instantly end continuous
flow, perform the same steps
as used for 'Enable
continuous flow'.
The fitting will resume normal
operation after you leave the
sensor range.