Cleaning Stop - WimTec Smart Betriebsanleitung

SMART
Configuring the functions
Range:
DIP switch 1
'ON' position:
Standard range (default setting).
'OFF' position: Short range – approx. 3 cm less, for small washbasins.

Cleaning stop:

DIP switch 2
Serves to disable the fitting prior to cleaning.
'ON' position: Cleaning stop function enabled.
'OFF' position: Cleaning stop function disabled (default setting).
Enable cleaning stop
Approach the infrared sensor
with your hand. The
sensor LED starts flashing, and
water begins to flow from the
faucet. After flashing 5 times,
the water flow is stopped,
and the cleaning stop is
enabled for 3 min.
Disable cleaning stop
The fitting will resume normal
operation 3 min after the
sensor has remained un-
triggered.
To instantly end the cleaning
stop, perform the same steps
used to enable the function.
5 x
WimTec SMART
Washbasin fitting
EN
ON
OFF
1 2 3 4 5 6
ON
OFF
1 2 3 4 5 6
17