Yamaha YZ85LW Fahrer- Und Wartungshandbuch Seite 186

STEERING HEAD INSPECTION AND ADJUSTMENT
Tighten the steering ring nut 3 using
steering nut wrench 4.
NOTE:
Set the torque wrench to the steering nut
wrench so that they form a right angle.
5PA30750
Loosen the steering ring nut one turn.
Retighten the steering ring nut using the
steering nut wrench.
WARNING
Avoid over-tightening.
Check the steering stem by turning it lock
to lock. If there is any binding, remove the
steering stem assembly and inspect the
steering bearings.
Install the upper bracket 5, steering stem
nut 6, handlebar 7, handlebar upper
5PA30760
holder 8 and number plate 9.
NOTE:
The upper handlebar holder should be
installed with the punched mark a for-
ward.
Insert the end of fuel breather hose 0 into
the hole of the steering stem.
CAUTION:
First tighten the bolts on the front side of
the handlebar holder, and then tighten
the bolts on the rear side.
3 - 33
INSP
ADJ
Steering nut wrench:
YU-33975/90890-01403
Steering ring nut (initial tighten-
ing):
38 Nm (3.8 m • kg, 27 ft • lb)
Steering ring nut (final tighten-
ing):
4 Nm (0.4 m • kg, 2.9 ft • lb)
Steering stem nut:
115 Nm (11.5 m • kg, 85 ft • lb)
Handlebar upper holder:
27 Nm (2.7 m • kg, 19 ft • lb)
Pinch bolt (upper bracket):
22 Nm (2.2 m • kg, 16 ft • lb)
Number plate:
7 Nm (0.7 m • kg, 5.1 ft • lb)