Description Of The Appliance; Preparing The Appliance; English 13 - Kärcher SDP 14000 Level Sensor Betriebsanleitung

 To separate the machine from the
mains, pull the plug and not the power
cord.
 Do not scrape the power cord across
sharp edges and ensure that it does not
get pressed.
 The voltage indicated on the type plate
must correspond to the voltage of the
electrical source.
 To avoid risks, all repairs and replace-
ment of spare parts may only be carried
out by the authorised customer service
personnel.
 Follow the rules for electrical safety of
equipment:
When pumping out swimming pools,
garden ponds and fountains, only using
a earth-leakage circuit breaker with a
nominal leakage current of max. 30 mA
with the immersion pump. Do not oper-
ate the pump if there are persons locat-
ed in the swimming pool or the garden
pond.
For safety reasons, we recommend that
you operate the appliance only via a
earth-leakage circuit breaker (max. 30
mA).
The machine should only be operated
with a power source with proper earth-
ing and connected safety conductors.
The electrical connection of the system
may only be performed by a qualified
electrician. Please follow the respective
national regulations!
 This device is not intended for use by
persons (including children) with re-
duced physical, sensory or mental abil-
ities or lacking experience and/or
knowledge, unless they are supervised
by a person responsible for their safety
or are instructed by these persons on
the use of the device. Children should
be supervised, to ensure that they do
not play with the device.
Start up
Please follow the safety instructions before
start-up!
Please keep in mind that the label "100%
tested" may not be removed from the
pump. If the label is removed, there will be
no more warranty for the tightness of the
pump.

Description of the Appliance

1 Power cord with plug
2 Level Sensor
3 Ventilation button
4 Carrying handle
5 Hose connection 1" (25.4 mm) und 1
(38 mm)
6 Flat seal
7 Backflow valve
8 Cable connector

Preparing the Appliance

Illustration
 For a 1 / " (38mm) hose, the hose con-
1
2
nection must first be sawed off.
Illustration
 Place the flat seal into the hose connec-
tion piece.
If you would like to prevent the water
that is standing in the hose or above the
pump after the pump has been turned
off, we recommend that you use the in-
cluded backflow valve. Before inserting
the backflow valve, the flat seal must be
removed. Pay attention to correct posi-
tioning.
 Screw the hose connection on to the
pump
 Push the hose on the hose connection
and fasten it with appropriate hose clip
Note:
The larger the hose diameter and the short-
er the hose, the higher the feed rate.
/ "
1
2

English 13