Description Of The Appliance; Preparing The Appliance - Kärcher SCP 9000 Betriebsanleitung

Operation

Description of the Appliance

1 Power cord with plug
2 Level sensor
3 Level sensor stopper
4 Ventilation button
5 Carrying handle
6 Hose connection 1" (25.4 mm)
7 Cable connector

Preparing the Appliance

Please follow the safety instructions before
start-up!
Illustration
For a 1" (25.4 mm) hose, the hose con-
nection must first be sawed off
Note:
The larger the hose diameter and the short-
er the hose, the higher the feed rate.
Illustration
Screw the hose connection on to the
pump
Push the hose on the hose connection
and fasten it with appropriate hose clip
Illustration
Extend the folding feet (only SCP
9000).
Illustration
In automatic operations mode, set the
required switching height by clamping
the level sensor cable in the stopper.
Illustration
In manual operations mode, align the level
sensor upward (cable pointing downward).
Tip: Push the cable of the level sensor like a
loop through the handle.
Illustration
Place the pump on a level, stabile sur-
face in the liquid to be transported, en-
sure that it is standing firmly or immerse
it using a rope tied to the handle.
The suction area should not be blocked
fully or partially through the impurities.
Illustration
When installing the pump, you must
make sure that the pump can be sub-
merged up to the max. submersion
depth (h1) of 9 m, but only has a max.
flow height (h2) of 6 m (SCP 9500) or 7
m (SDP 9000).
The flow height indicates the height dif-
ference between the water level and
water exit at the end of the flow hose.
You have to adhere to the flow height
for the pump to flow. This must be ob-
served throughout the entire pump run,
as the flow height will increase with a
decreasing water level (due to the
pumping).
– 7
EN 15