Special Accessories - Kärcher SDP 14000 Level Sensor Betriebsanleitung

The figures of the following special accessories can be found on page 4 of these instruc-
tions.
6.997-346.0 Suction hose, by the
meter, 1"(25.4mm)
25 m
6.997-353.0 Stainless steel pre-
filter
6.997-418.0 Pump connection
G1 (33.3 mm) incl.
Check valve
Caution
To avoid risks, all repairs and replacement of spare parts may only be carried out by the
authorised customer service personnel.
Fault
Pump runs but does
not transport
16 English

Special accessories

Vacuum-tight spiral hose, to be cut into individual
lengths.
The removable stainless steel prefilter increases
the functional safety of the immersion pump and
protects the pump impeller from clogging. Suitable
for all submersion pumps with level sensor.
Fits 1" (25.4 mm) or 1
(33.3 mm) threaded connection, including backflow
valve, flat seal and hose clamp. Insert the backflow
valve instead of the flat seal to prevent the water
from returning into the pump.
Troubleshooting
Cause
Air in the pump
Suction area blocked
(only in manual mode) Water
level below the minimum water
level
/ " (31.7 mm) hoses. With G1"
1
4
Remedy
Press the ventilation button or plug
in/ disconnect the mains plug of the
pump a few times till the fluid gets
sucked.
Pull out the mains plug and clean the
suction area
Immerse, whenever possible, the
pump deeper into the liquid or, in
case of SCP 12000, proceed accord-
ing to instructions in the chapter on
flat suction.