Belden Hirschmann EAGLE40-03 Referenzhandbuch Seite 539

2 5 .2 .1 show lldp globa l
Display the LLDP global configurations.

Mode: Command is in all modes available.

Privilege Level: Guest

Format: show lldp global
2 5 .2 .2 show lldp port
Display the port specific LLDP configurations.

Mode: Command is in all modes available.

Privilege Level: Guest

Format: show lldp port [<P-1>]
Parameter Value
P-1 slot no./port no.
2 5 .2 .3 show lldp re m ot e -da t a
Remote information collected with LLDP.

Mode: Command is in all modes available.

Privilege Level: Guest

Format: show lldp remote-data [<P-1>]
Parameter Value
P-1 slot no./port no.
2 5 .3 lldp
Configure of Link Layer Discovery Protocol on a port.
2 5 .3 .1 lldp a dm in-st a t e
Configure how the interface processes LLDP frames.

Mode: Interface Range Mode

Privilege Level: Operator

Format: lldp admin-state <P-1>
Parameter Value
tx-only
P-1
rx-only
tx-and-rx
disable
2 5 .3 .2 lldp fdb-m ode
Configure the LLDP FDB mode for this interface.

Mode: Interface Range Mode

Privilege Level: Operator

Format: lldp fdb-mode <P-1>
Parameter Value
P-1 lldp-only
mac-only
both
auto-detect
2 5 .3 .3 lldp m a x -ne ighbors
Enter the LLDP max neighbors for interface.

Mode: Interface Range Mode

Privilege Level: Operator

Format: lldp max-neighbors <P-1>
Parameter Value
1..50
P-1
92
Meaning
Meaning
Meaning
Interface will only transmit LLDP frames. Received frames are not processed.
Interface will only receive LLDP frames. Frames are not transmitted.
Interface will transmit and receive LLDP frames. This is the default setting.
Interface will neither transmit nor process received LLDP frames.
Meaning
Collected remote data will be based on received LLDP frames only.
Collected remote data will be based on the switch's FDB entries only.
Collected remote data will be based on received LLDP frames as well as on the
switch's FDB entries.
As long as no LLDP frames are received, the collected remote data will be based
on the switch's FDB entries only. After the first LLDP frame is received, the
remote data will be based on received LLDP frames only. This is the default
setting.
Meaning
Enter a number in the given range.
RM CLI EAGLE40-03
Release 04.1 03/2021