CEX ELECTRONIC MPS
®
Schaltplan
Wiring diagram
2
1
1. Elektronik
2. Heizelement
3. Sicherheitsdruckbegrenzer SDB
4. Klemmleiste
5. Sicherheitstemperatur begrenzer STB
1. Electronic circuitry
2. Heating element
3. Safety pressure cut-out
4. Terminal strip
5. Safety thermal cut-out
7. Elektroanschluss
Nur durch den Fachmann!
Zu beachten sind:
• VDE 0100
• Bestimmungen der örtlichen
Energie und Wasserversorgungs
unternehmen
• Technische Daten und Angaben auf
5
Typenschild
• Gerät an den Schutzleiter
anschließen!
3
4
Bauliche Voraussetzungen
• Das Gerät muss dauerhaft an fest ver-
legte Leitungen angeschlossen werden.
Das Gerät muss an den Schutzleiter
angeschlossen werden. Maximaler
Kabelquerschnitt 6 mm
• Die Elektroleitungen müssen sich in
einem einwandfreien Zustand befinden
und dürfen nach der Montage nicht
mehr berührbar sein.
• Installationsseitig ist eine allpo-
lige Trennvorrichtung mit einer
Kontaktöffnungsweite von mindestens
3 mm pro Pol vorzusehen (z.B. über
Sicherungen).
• Zur Absicherung des Gerätes ist ein
Sicherungselement für Leitungsschutz
mit einem dem Gerätenennstrom an ge-
passten Auslösestrom zu montieren.
Elektroanschluss herstellen
Vergewissern Sie sich vor dem
Anschließen des Gerätes an das elek
trische Netz, dass die Strom versorgung
ausgeschaltet ist!
Elektroanschluss mit
Wandanschlussdose
Das Gerät ist über die vorhandene
Anschlussleitung an eine Geräte-
anschlussdose anzuschließen. Bei
Bedarf brechen Sie dazu eine der drei
Kabeldurchführungen (rechts, links oder
oben am Gerät) aus.
7. Electrical connection
Only by a specialist!
Please observe:
• VDE 0100
• The installation must comply with
• The rating plate and technical speci
• The unit must be earthed!
Structural prerequisites
• The appliance must be installed via a
.
2
• The electric wiring should not be
• An all-pole disconnecting device (e.g.
• To protect the appliance, a fuse element
Electrical connection
Check that the power supply is
switched off prior to electrical connec
tion!
Electrical connection with pre
installed power cable
The appliance is to be connected with the
pre-installed power cable to a terminal
box. If necessary, use one of the three pre-
determined breaking points for the cable
entry (at the right, left or top).
10
current IEC and national local regula
tions or any particular regulations,
specified by the local electricity sup
ply company
fications
permanent connection. Heater must be
earthed! A maximum cable size must
be observed: 6 mm
2
.
injured. After mounting, the wiring
must not be direct accessible.
via fuses) with a contact opening width
of at least 3 mm per pole should be pro-
vided at the installation end.
must be fitted with a tripping current
commensurate with the nominal cur-
rent of the appliance.